electric boiler heating system is very similar to a gas or oil boiler but it uses electricity to heat water for your home
rather than gas/oil.
Why choose an electric boiler?
No gas or oil needed. If you live in one of the 2 million homes homes in the UK that is not connected to the gas
network or your home has gas boiler restrictions e.g. listed buildings, an electric boiler is the best solution.
The Control functions available are:
1.Multiple stalls/banks setting function:
There are four heated stalls/banks available to meet different functional requirements.
2.Wide temperature setting function:
The water temperature can be set in the range of 30-85℃.
3.Automatic temperature control function:
The controls will shut down the boiler when the water temp reaches the set temperature
.when the return water temperature is 20℃ below the set temperature ,the boiler
will automatically restart.
4.clock set function:
Set the time for the clock.
5.Start(boot) and shutdown time function:
Time settings can be arranged to switch the boiler on/off to meet different consumer needs.
6.Over-temperature protection function:
When the heater temperature exceeds 95℃ and over-temperature protection device will cut in to shut down the boiler.
7.Dry protection function:
When the temperature exceeds 110℃ ,a dry start protection device will cut out the boiler.
Disconnection of the power supply and troubleshooting of the problem is required before
the boiler can be restarted.
8.Leakage protection function:leakage protection will cut out the boiler.
9.Low water pressure protection function:
When the system pressure is below 0.04 MPa(0.4bar),the safety pressure relief valve will
protect the system.
10.Overpressure protection function:
When the system pressure exceeds 0.4Mpa(4bar),the safety pressure relief valve will
protect the system.
11.system pressure display function:
The pressure gauge displays the system working pressure.
12.Frost protection function:
When the system temperature is below 3℃, the system automatically start heating boiler,
when the temperature is heated to 10℃, the heating cycle will stop.
Standard filtration system to ensure the system is working properly.
14.Fault code display function:
Fault code display for ease of fault diagnosis and maintenance.